CCTV maintenance works best when it follows a repeatable set of checks, not quick visual inspections that miss the real causes of future faults. For sites in Northam, Devon, this matters because a system that looks fine on a monitor can still fail during playback, export or incident review. A common cause of repeat faults is connectivity. Servicing checks include confirming network and PoE stability, reviewing switch and port behaviour where accessible, and testing for intermittent link drops that create cameras offline or unstable feeds. This structured approach helps separate a camera fault from an upstream issue such as cabling, power, network configuration or a recorder port problem. Next, we review camera performance across the areas you rely on most. We look for intermittent feeds, image degradation, focus issues, low-light limitations and changes in scene exposure that can reduce identification quality. Where it is safe and appropriate, we confirm camera settings and positioning still match operational needs, especially if the site layout, lighting or access routes have changed since the system was installed. All checks are carried out by NICEIC-approved engineers with a commercial-first mindset, aligned with BS EN 62676 expectations where applicable. The goal is not to sell changes; it is to confirm what is working, identify what is drifting, and give you clear, practical next steps. By confirming recording reliability and system stability now, you reduce the risk of discovering a fault at the worst possible time.